04 Sep

Juniper to Fortinet ISIS configuration

Hoo boy. I have been trying to configure a small mesh network for a fault-resilient office setup. In my network, I have a ‘square’ setup, two VMX routers, two Fortigate virtual firewall appliances, all running on top of ESXi 6.5 (two physical hypervisors). It looks like this:

Anyway. In order to redistribute the default route(s) received from the upstreams, I wanted to use iBGP inside the ‘square’ of devices.. iBGP relies on an IGP, so I chose the coolest one available, ISIS.

This is a very simple setup, but there was no way I could get an adjacency to form between the router and firewall (green to black in the diagram). I tried 100 things (changing hello intervals (pointless!), LSP generation times, MTU, MTU, MTU and several other desperate things like disabling hello-padding, enabling and disabling ‘adjacency checking’ on the Forti-devices).. Nothing.

Eventually, I enabled trace-options on the Junos side of things – I could see my adjacencies with the Forti-devices stuck in the ‘Initializing’ phase, implying the three-way-handshake was busted.. The traceoptions showed some guff, but nothing that pointed to an easily solvable problem (i.e. not MTU)..

Finally, using the debug features of the Fortigate box, I found:

Bearing in mind, there isn’t a single bit of IPv6 config on any of these devices (yet, it’s going to be fully dual stack, don’t worry!) – so what was up.. Turns out, the Fortigate devices were a bit sensitive, and needed the following knob in my Juniper ISIS config:

All of a sudden.. My ISIS adjacencies are up and solid.

Hopefully this will be useful to some sucker in future who chooses to use ISIS in their corporate network 🙂

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.